Category: Wireless

0

Cisco DNA Center: Wireless Assurance

Wireless Assurance gives you the visibility and insights to solve for network challenges in the past, present, and future. Steps:1. Network discovery CLI and SNMP are required credentials global or task specific Global settings: Design > Network Settings > Site > Device Credentials Once discovery is done all Devices appear in Inventory. Make sure status is ok for each column: Reachability...

0

Cisco WLC ACL using CLI

Configuring access-lists on the Cisco Wireless Controller could be tough with line by line and a lot of clicks. Using CLI the idea is the same, but Notepad++ is very helpful in editing. The one rule consist of the following settings: rule number direction source address destination address protocol source port destination port action permit ip any any (outbound) – allow...

Cisco WLC Captive-bypass

When ‘enabled‘ you have to manually open a webpage to get the screen. When ‘disabled‘ it will auto launch. config network web-auth captive-bypass enable NOTE: ISE 2.2 supports Apple Mini-Browser (CNA), no need this command anymore…

0

Cisco WLC Flex connect names

Cisco WLC doesn’t “like” group names with several words and space: Therefore when you are trying to use GUI interface and add AP to this flexconnect group, it opens the group with some weird symbols (repeats 2 last): There is no such issue with a “one word named” group. Workaround: use CLI (Cisco Controller) >config flexconnect group “Oriole Lane” ap add...